Bantam BC8HP Betriebsanleitung PDF herunterladen (Seite 21)

STATION

Warning and error messages

The output is connected to a battery with incorrect polarity.

This will be displayed in case of detecting an interruption of the

connection between battery and output or voluntarily disconnecting the

charge lead during the operation of charge or discharge on output.

The voltage of one of the cell in the Lithium battery pack is too low. Please

check the voltage of cells one by one.

The cell-count of Lithium battery pack was selected incorrectly. Verify the

cell-count carefully.

The charger detects the voltage is lower than you set at Lithium program.

Please check the cell-count of the battery pack.

BC8DX incorporates a various functions of protective and monitoring the system to verify functions and

the state of its electronics. In any case of occurring error, the screen displays the cause of error that is

self-explanatory with audible sound.

The charger detects the voltage is higher than you set at Lithium program.

Please check the cell-count of the battery pack.

There are bad connection at the individual connector. Please check the

connector and cables carefully.

There is a short-circuit at output. Please check the charging leads or

output cable of battery pack.

The voltage of input power drops below the limit.

There happens the malfunction at the charger circuit by any reason. The

charger should be repaired at the factory.

The voltage of one of the cell in the Lithium battery pack is too high.

Please check the voltage of cells one by one.

The internal temperature of the unit goes too high. Cool down the unit.

Check connection ...

Reversed polarity

STOP/ESC

Check charger ...

Over-temperature

STOP/ESC

Check connection ...

Connection break

STOP/ESC

Check cell-count ...

Incorrect cell-count

STOP/ESC

Check charger ...

Break-down

STOP/ESC

Check connection ...

Short-circuit

STOP/ESC

Check battery ...

Low voltage

STOP/ESC

Check balancer ...

Comm. error

STOP/ESC

Balance error ...

Low cell vol.

STOP/ESC

Check battery ...

High voltage

STOP/ESC

Balance error ...

High cell vol.

STOP/ESC

Balance error ...

Bad connection

STOP/ESC

Balance error ...

Ref. data fail

STOP/ESC

Check power ...

Low input volt

- 21 -

STOP/ESC

The balancing circuit had been damaged. The balance function can not be

used, and the charger needs to be repaired at our factory.

The charger can not read out the individual voltages correctly because of

malfunction of main processor. The charger needs to be repaired.

1 2 ... 16 17 18 19 20 21 22 23 24

Kommentare zu diesen Handbüchern

Keine Kommentare

Bantam BC8HP Betriebsanleitung Seite 21

Kommentare zu diesen Handbüchern