Bantam BC8HP Spezifikationen PDF herunterladen (Seite 4)

Warnings and safety notes

Never leave the charge unsupervised when it is connected to its power supply. If any

malfunction is observed immediately terminate the process and refer to the operation

manual.

Keep away the unit from dust, damp, rain, heat direct sunshine and vibration. Do not

drop it.

The circuit of the unit is designed to be powered by 11 to 18V DC only.

This charger and the battery to charge or discharge should be set up

on a head-resistant, non-inflammable and non-conductive surface.

Never place them on a car seat, carpet or similar. Keep all the

inflammable volatile materials well away from operating area.

Be careful to touch the charger body when charging or discharging at

charger’s maximum power. It may be very hot and can cause a physical

damage on your finger or body.

Be sure to understand the information of the battery to be charged or discharged

accurately. If the program is set up incorrectly the battery can severely be damaged.

Especially Lithium battery can cause a fire or an explosion by over-charging.

NiCd/NiMH voltage level: 1.2V/cell

allowable fast charge current: 1C ~ 2C

discharge voltage cut off level: 0.85V/cell(NiCd), 1.0V/cell(NiMH)

LiIo voltage level: 3.6V/cell

max. charge voltage: 4.1V/cell

allowable fast charge current: 1C or less

min. discharge voltage cut off level: 2.5V/cell or higher

LiPo voltage level: 3.7V/cell

max. charge voltage: 4.2V/cell

allowable fast charge current: 1C or less

discharge voltage cut off level: 3.0V/cell or higher

LiFe voltage level: 3.3V/cell

max. charge voltage: 3.6V/cell

allowable fast charge current: 4C or less (e.g. A123M1)

discharge voltage cut off level: 2.0V/cell or higher

- 4 -

Bantam BC8HP Spezifikationen Seite 4